COMMUNITY




more in community

TONIGHT: Downbeat Switch w/ The Dream Machine At The Republic

It was a rock smorgasbord at The Republic last Thursday, where The Dream Machine warmed the crowd for Sam Robinson and the Groove-Elators and closing act Beef Lizard. As the opening act, The Dream Machine set was toned down just a touch. This was certainly not a bad...

TONIGHT: James Lawson Returns To The Republic For ROFL

James Lawson is a comedian who can and will hit from all angles. Whether he's performing clean comedy that can appropriate for even the most uptight aunt, or making audience beg for more at clubs and venues all over the East Coast with a bit more edge, James Lawson is...

TONIGHT: Jon D. Miller Takes Over ROFL @ Republic

Jon D Miller is a comedian that most should know about. After all, this Richmond-based comic has been performing across the country for over 10 years. If you've see him, then you already know that he is an act to remember. Jon D Miller is a comedian that most should...

TONIGHT: Radio Rubber Room Dance Party At On The Rox!

It's finally here, ladies and gentlemen! We at RVA Magazine and Rubber Room Radio are proud to present a night of epic proportion, with special guests Air Circus and Tom Eats Jerry. It's finally here, ladies and gentlemen! We at RVA Magazine and Rubber Room Radio are...

TONIGHT: Splendid Suns w/ The Dream Machine At The Republic

Last Wednesday at The Republic, not only did we see The Dream Machine and Big Enough, we were also pleasantly surprised by New York foursome J. Aims and the Fever as they finished up a mini-tour up and down the East Coast. Three good bands and three impressive sets...

TONIGHT: ROFL At The Republic Featuring Antoine Scott

Antoine Scott is an equal opportunity comedian. Whether it's sharing the stage with the likes of Kevin Hart, Tracy Morgan among many others, or performing for the troops overseas, Antoine Scott will make any any audience laugh whether you like it or not. Now, he comes...

No Results Found

The posts you requested could not be found. Try changing your module settings or create some new posts.